* Specifically designed with strong, yet soft, plastic material that won't damage coaxial, data, electrical, or other wire and cables. Additionally, by using a special PE UV material, no electrical shorts are created (as seen with staples or metal clips).
* Added ridges 'lock' the clip in place, allowing it to automatically adjust to a wide variety of Cable and wires sizes. Allows for near 360 degrees of grip, so that the Cable will not slide back and forth for most sizes.
* High Quality, Outdoor Rated, UV Protected PE Clip and Long-Life Yellow Zinc plated screw anchors are designed to be strong and easy to install. They are pre-installed into the clip, saving time and making installation much easier.
* Twin mounting head allow for the use of either a 1/4" hex drive bit, or a standard #2 Phillips head drill bit. A standard #2 Phillips head screwdriver may also be used to install the clips.
* Package of 50 White Twin Clips. Clips allow for an additional 16-30AWG wire to be installed alongside the primary wire, for use with grounding of antennas and satellites. Proudly packaged in the USA.
THE CIMPLE CO, A Family Company located in the USA, is proud to offer these clips. They are available with Nail or Screw fastener, manufactured with high quality UV protected materials and long-life outdoor rated fasteners. By using specially designed clips for coax, data, and other cables-there is no loss in the wire by 'pinching or crushing' the outer jacket. This leaves the integrity of the cable intact to prevent any loss of signal, while providing a long-life installation. Screw clips are designed to be removed and adjusted if every needed; nail clips are great for baseboards, most stucco, and brick mortar. Available in sizes to fit a single cable, or two - and in black and white.
